WIKA FSD-3 Mode D'emploi page 18

5. Commissioning, operation
5.5 Parameter
Parameter
SP1/SP2
FH1/FH2
EN
RP1/RP2
FL1/FL2
EF
RES
DS1/DS2
DR1/DR2
OU1 / OU2
UNIT
SETF
SETT (option)
DISM
DISR
PAS
TAG
18
Description
Hysteresis function: Switch point, switching output (1 or 2)
Window function: Window high switching output (1 or 2)
Hysteresis function: Reset point, switching output (1 or 2)
Window function: Window low switching output (1 or 2)
Extended programming functions
Reset the set parameters to the factory settings
Switch delay time, which must occur without interruption before any electrical signal change occurs (SP1 or SP2)
Switch delay time, which must occur without interruption before any electrical signal change occurs (RP1 or RP2)
Switching function switching output (1 or 2)
HNO = hysteresis function, normally open
HNC = hysteresis function, normally closed
FNO = window function, normally open
FNC = window function, normally closed
Unit switching
Adjustment: Minimum and maximum flow
Measuring range scaling of 4 ... 20 mA temperature output
"Min" determines at which temperature the output signal is to be 4 mA.
"Max" determines at which temperature the output signal is to be 20 mA.
Display value in display mode
FLOW = current flow value; TEMP = current temperature value; OFF = display off;
SP1/FH1 = function switch point 1, RP1/FL1 = function reset point 1,
SP2/FH2 = function switch point 2, RP2/FL2 = function reset point 2
Rotate display by 180°
Password input, 0000 = no password; password input digit by digit
Input of a 16-figure alphanumeric measuring point number
WIKA operating instructions flow switch, model FSD-3