koban KMD-16 Mode D'emploi page 97

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

KMD-16
TRMS Multimeter
4.
For current measurements up to 10A AC, set the function switch to the 10A/HZ/% position and insert the red test lead
plug into the 10A jack.
Press the MODE button to indicate "AC" on the display.
5.
6.
Remove power from the circuit under test, then open up the circuit at the point where you wish to measure current.
Touch the black test probe tip to the neutral side of the circuit. Touch the red test probe tip to the "hot" side of the
7.
circuit.
8.
Apply power to the circuit.
9.
Read the current in the display.
97
www.grupotemper.com

Publicité

Table des Matières
loading

Table des Matières