Samlex Solar SRV-100-30A Manuel D'utilisation page 14

1/2" diameter
1/2" diameter
SECTION 7 |
1/4" captive brass nut
1/4" captive brass nut
Typical Installation of a Well-Nut
Fig. 7.4. Well-Nut is inserted
into a pre-drilled hole with
its flange against the outer
surface. There is no need
for access to the
inner side.
7. To install the Well-Nuts, drill holes 1¼" deep at the marked positions using a ½" size drill bit. Make sure
that drilling does not interfere with pre-existing wiring installations.
8. Apply silicone or any appropriate sealant recommended by your RV dealer generously to the drilled holes
for water-proofing.
9. Insert the ¼" Well-Nut into the drilled holes so that only the flange section remains above the roof
surface (Fig. 7.4).
10. Fasten the mounting brackets to the roof surface by inserting the ¼ x 1¼" serrated flange bolt into the
Well-Nut (Fig. 7.5). Tighten using a 3/8" wrench to a recommended torque of 15 lbs. When the serrated
flange bolt is screwed into the Well-Nut, the material surrounding the well nut bulges slightly securing
the structure to the RV roof (Fig. 7.6 & 7.8).
11. Make sure all bolts and mounting brackets are covered by good amounts of suitable RV sealant
recommended by your local RV dealer.
¼"-20 x 1¼" Flange Bolt
¼" Flat Washer
14 | SAMLEX AMERICA INC.
ange
ange ange
1/2" diameter
1/2" diameter
1/4" captive brass nut
Solar Panel Installation
1/4" captive brass nut
Fig. 7.5. The 5-hole mount-
ing bracket is placed against
the flange of the Well-Nut
and is secured by the bolt
engaging the captive brass
nut.
Mounting Bracket
Well-Nut
Fig. 7.8 Attaching 5-hole mounting bracket to RV Roof
Fig. 7.6 . As the bolt is tight-
ened, the neoprene body of
the Well-Nut is compressed
and expanded, forcing it
tightly into the bolt's threads
and against the inner surface
of the thin RV roof material.
Solar
Module
RV roof material
up to approx. 3/8"
thickness
Rubber bushing material expands
when bolt is tightened to securely
anchor hardware
Fig. 7.7. Installed in a blind
hole in a solid material,
the body of the Well-Nut
expands tightly against the
walls of the hole, effect-
ing a secure, dependable
fastening.