Installation Overview - Samlex Solar SRV-100-30A Manuel D'utilisation

SECTION 4 |
WARNING!
1. SAFETY: Please read Section 1: General Safety before starting installation.
2. PRECAUTIONS WHEN WORKING WITH CHARGE CONTROLLER MODEL NO. SCC-30AB: If two or
more solar panels are connected in series/parallel make sure that the sum of the Short Circuit
Current ratings of all panel strings does not exceed 80% of the Charge Controller's current rat-
ing i.e. 24 Amps for the 30 Amp Charge Controller. The Open Circuit Voltage of the solar array
i.e. the maximum voltage across the array should not exceed 50V.
Block Diagram of Installation (Fig 4.1)
1. Read the manual in detail and understand the installation procedure.
2. Open the packaging and check to make sure that all parts have been received as per the List of
Components (page 6).
3. Arrange for the required tools to carry out the installation. A sample list of tools (not exhaustive) is
provided in Section 4.
4. Determine the mounting location of the solar panel(s) on the roof of the RV.
5. Mount the Charge Controller at the desired location (see Section 6).
6. Pass the cable from the solar panels to the interior of the RV (See Section 7).
7. Wire the battery to the Charge Controller through fuse and then the solar panel to the Charge
Controller ensuring correct polarity is observed (See Section 7).
8. Secure the solar panel to the RV roof (See Section 7).

Installation Overview

Fuse within 7"
of battery post
Fig. 4.1. Installation Block Diagram Philips drive screw driver
Solar
Panel
Solar
Charge
Controller
Battery
SAMLEX AMERICA INC. | 11