Removing The Rear Lint Screen; Removing The Activepure® Cell - vollara FRESH AIR EVEREST Mode D'emploi

REMOVING THE REAR LINT SCREEN

CAUTION: Unplug the unit before performing any
maintenance procedures.
To Remove:
Rear Lint Screen
follow steps 1 - 5
ActivePure® cell
follow steps 1 - 9
REMOVING THE ACTIVEPURE® CELL
8
(FOLLOW STEPS 1 - 5)
3. Remove back
cover. Press
the sides
to unlatch,
then tilt the
bottom out
to remove.
(FOLLOW STEPS 1 - 9)
6. Unlock the
ActivePure®
cell connector
by pressing
on the
connector's
locking tabs.
9. Remove
two (2)
thumbscrews.
WARNING: Do not operate FreshAir Everest without
the rear lint screen and back cover properly installed.
1. Unplug unit.
4. Remove
two (2)
thumbscrews
securing the
top of the lint
screen.
7. Pull the
connector
straight out
to unplug.
10. Remove the
ActivePure®
cell(s) from
the unit.
1 2
2. Remove
the back
cover
screw.
5. Remove
the lint
screen
by pulling
back the
top, then
lifting up
and out.
8. Unlock and
remove the
connector
for cell 2 (if
installed).
ActivePure® cells must be
replaced every twelve (12)
months if used continuously, or
every two (2) years if used less
than 12 hours per day, even if
the UV lamp is still operating.
NOTE: Use genuine Vollara
replacement parts only. Parts
from anyone other than Vollara
may damage your unit and void
your warranty.