Removing The Filter Assembly - vollara Air & Surface Pro Manuel D'utilisation

GENERAL MAINTENANCE (CONTINUED)
Cleaning the Case
Wipe the unit with a soft cloth dampened (not wet) with water. Do not use chemicals or solvents. Vacuum the Top and Rear Grills
periodically to remove any lint buildup.
Cleaning the ActivePure Cells
Remove the ActivePure Cells and carefully vacuum accumulated lint. Do not wash the ActivePure Cells. Damage from water
®
may result.
Filter Assembly Cleaning
1. When visibly dirty, simply remove the Rear Filter Assembly from the unit (see page 8), and with a hand-held vacuum,
remove the heavy particulate. This method will extend the life of the Filter Assembly.
2. If the Filter Assembly can't be cleaned by vacuuming, replace the Filter Assembly.
Filter Assembly Replacement
Contact your Independent Distributor/Contractor or Vollara® Customer Service at 800.989.2299 for replacement filters (see
pages 8 – 9 for removal and installation instructions).
NOTE: Filter Assembly life will vary based on the operating environment.
Changing the ActivePure Cell
The ActivePure Cell should be replaced when REPLACE ACTIVEPURE CELL appears on the display, or twelve (12) months when
used continuously To change the ActivePure Cell, follow the instructions on page 10.

REMOVING THE FILTER ASSEMBLY

• Unplug the unit before performing any maintenance procedures
• Do not operate the Vollara Air & Surface Pro without the Filter Assembly and Back Cover
WARNING
1. Unplug unit
properly installed
2. Press the top of
the back cover to
release the back
panel
3. Lift up to remove
the back panel
4. Use the included
screwdriver to
unscrew the Filter
Assembly
Hand Strap
5. Lift the Filter
Assembly up and
out to remove
9