Removing The Filter Assembly - vollara AIR & SURFACE PRO+ Mode D'emploi

GENERAL MAINTENANCE (CONTINUED)
Cleaning the ActivePure Cell
Remove the ActivePure Cell and carefully vacuum accumulated lint. Do not wash the ActivePure Cell. Damage from water may
®
result.
Filter Assembly Cleaning
1. When visibly dirty, simply remove the Rear Filter Assembly from the unit (see page 8), and with a hand-held vacuum,
remove the heavy particulate. This method will extend the life of the Filter Assembly.
2. If the Filter Assembly can't be cleaned by vacuuming, replace the Filter Assembly.
Filter Assembly Replacement
Contact your Independent Distributor/Contractor or Vollara® Customer Service at 800.989.2299 for replacement filters (see
pages 8 – 9 for removal and installation instructions).
NOTE: Filter Assembly life will vary based on the operating environment.
Cleaning the Purifier Plate
Remove the Filter Assembly (see page 9). Carefully remove the Purifier Plate from the card cage by grasping the middle of the
edge nearest to you, and slowly pull it straight out. If you are in an environment where there are fats, oils, or grease, such as in a
kitchen, start by cleaning with denatured alcohol and a soft bristle brush. This will cut the grease without leaving a residue.
For all applications - Clean with a mixture of one part water and one part ammonia to remove contaminants. Place the plate into
a shallow dish, and pour enough of the water/ ammonia solution into the dish to just cover plate. Allow the plate to soak for no
more than 10 minutes.
Remove plate and scrub with a soft bristle brush. Rinse thoroughly. Let air-dry for 24 hours or use a blow dryer to dry
thoroughly.
NOTE: Using a Purifier Plate that is NOT completely dry may damage the plate.
The unit will display a REPLACE PLATE message if the purification plate needs to be replaced."
Changing the ActivePure Cell
The ActivePure Cell should be replaced when REPLACE ACTIVEPURE CELL appears on the display, or twelve (12) months when
used continuously To change the ActivePure Cell, follow the instructions on page 10.

REMOVING THE FILTER ASSEMBLY

• Unplug the unit before performing any maintenance procedures
• Do not operate the Vollara Air & Surface Pro+ without the Filter Assembly and Back Cover
WARNING
1. Unplug unit
properly installed
2. Press the top of
the back cover to
release the back
panel
3. Lift up to remove
the back panel
4. Use the included
screwdriver to
unscrew the Filter
Assembly
Hand Strap
5. Lift the Filter
Assembly up
and out to
remove
9