Settings & Adjustments - vollara AIR & SURFACE PRO+ Mode D'emploi

SETTINGS & ADJUSTMENTS
The Vollara Air & Surface Pro+ can be turned on or off, and adjusted, using the control panel on the front of the unit.
NOTE: If you are operating your central heating and air conditioning fan or other ventilation system continuously, set
the coverage up to the total ventilated indoor area. Otherwise, set the coverage up to the size of the room. Do not
exceed the size of the ventilated indoor area when setting the purifier level.
POWER (STAND BY)
Turns the unit ON and OFF.
FAN UP/FAN DOWN
Adjusts the five speed fan.
AREA A·PURE+
Works when unit is in A·PURE + Mode to set the
purifier level for the indoor area. The level is
indicated by both a horizontal bar graph and
square footage. The unit will switch to A·PURE
Mode, if the Purifier DOWN button is pressed.
A·PURE/A·PURE+
Toggles the unit between A·PURE Mode
(ActivePure and Ionization) and A·PURE+ Mode
®
(1 ActivePure
®
Purification Plate).
REMINDER RESET
Clears the maintenance reminders after
performing routine maintenance.
DEPART ROOM
Turns on and adjusts the timer for the Depart
Room Mode. Each press of the Depart Room
button will change the time by 2/4/8 hours, up
to eight hours, then off. The Depart Room
Mode should be operated in unoccupied areas only.
NOTE: "Unoccupied areas" includes pets. Some pets, like humans, may experience adverse reactions from exposure to
increased levels of ozone and should not be present during DEPART ROOM MODE operation.
6
Cell, Ionization, and
A·PURE / Reminder
A·PURE+ Reset
Power
ON/OFF
Depart Room
ON/SET/OFF
sq. ft. UP Fan DOWN
sq. ft. DOWN Fan UP