Installing The Purifier Plate & Activepure Cell - vollara AIR & SURFACE PRO+ Mode D'emploi

INSTALLING THE PURIFIER PLATE & ACTIVEPURE
WARNING
12
• Unplug the unit before performing any maintenance procedures
• Do not operate the Vollara Air & Surface Pro+ without the Filter Assembly and Back Cover
properly installed
1. Slide the ActivePure Cell up and into
the unit. Be sure the back lip of the
ActivePure Cell engages the two
slotted protrusions at the rear of the
plate cage, and that the angle
brackets and studs are correctly
aligned.
3. Press the connector firmly until
the two tabs lock into place.
5. Replace the Filter Assembly,
inserting the bottom of the
Filter Assembly first.
7. Replace the Back Cover by
inserting the bottom in and
snapping into place..
CELL
®
2. Insert the two thumbscrews
and tighten. Insert the
ActivePure® Cell connector into
the plug on the plate cage.
4. Gently insert the Purifier Plate
between the guides
(inside the cage) until it stops.
6. Use the included screwdriver to
screw in the Filter Assembly.