Removing The Activepure Cells; Installing The Activepure Cells - vollara Air & Surface Pro Manuel D'utilisation

REMOVING THE ACTIVEPURE
CAUTION
WARNING
NOTE: Use genuine Vollara replacement parts only. Parts from anyone other than Vollara may damage your unit and void your
warranty.
1. Unlock the ActivePure
Cell connector by
pressing on the
connector's locking tabs.
INSTALLING THE ACTIVEPURE
WARNING
1.
Do not look directly at the glowing lamp. Prolonged exposure, even to reflected UV light,
can cause eye damage according to the American Conference of Governmental Industrial
Hygienists (ACGIH) Standards.
• Unplug the unit before performing any maintenance procedures
• Do not operate the Vollara® Air & Surface Pro without the Filter Assembly and Back Cover
properly installed
2. Pull the connector
straight out to unplug.
• Unplug the unit before performing any maintenance procedures
• Do not operate the Vollara Air & Surface Pro without the Filter Assembly and Back Cover
properly installed
Slide the ActivePure Cell up and into
the unit. Be sure the back lip of the
ActivePure Cell engages the two
slotted protrusions at the rear of the
unit, and that the angle brackets
and studs are correctly aligned.
3. Press the connector firmly until
the two tabs lock into place.
5. Use the included screwdriver to
screw in the Filter Assembly.
CELLS
®
3. Remove two
(2) thumbscrews.
CELLS
®
4. Slide the ActivePure
Cell down and out of
the unit.
2. Insert the two thumbscrews
and tighten. Insert the
ActivePure Cell connector into
the plug at the rear of the unit.
4. Replace the Filter Assembly,
inserting the bottom of the
Filter Assembly first.
6. Replace the Back Cover by
inserting the bottom in first
and snapping it into place.
11