Settings & Adjustments; Maintenance Reminders - vollara FRESH AIR EVEREST Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SETTINGS AND ADJUSTMENTS
FreshAir Everest can be turned on or off and adjusted using
either the included remote or the control panel on the front
of the unit . With the exception of the Reminder Reset button,
both the remote and the control panel buttons have the
same functions .
Fan UP
ActivePure® (RCI) On/Off
Power ON/OFF
Fan DOWN
Power ON/OFF
ActivePure®
On/Off

MAINTENANCE REMINDERS

REPLACE ACTIVEPURE® CELL
The ActivePure® cell is no longer working
correctly or may be improperly installed . Replace
the ActivePure® cell . See Removal and Installation
instructions on pages 8 - 9 . Replacement
ActivePure® cells are available from your Vollara
Business Owner .
• Please Note: The ActivePure® cell should be replaced
every twelve (12) months when used continuously
or two (2) years if used less that 12 hours a day,
even if the unit does not display this message .
Be sure to press the Reminder Reset button to clear the
reminder following regular maintenance (see below).
POWER (stand by)
Turns the unit ON and OFF.
FreshAir Everest can be turned on or off using either the
included remote or the control panel on the front of the unit.
Reminder
FAN UP/FAN DOWN
Reset
Adjusts the five speed fan.
NORMAL/HIGH
Turns the ActivePure® cell(s) on or off:
• RCI PUR. OFF
• RCI PUR. LOW
• RCI PUR. HIGH Fan and Ionization ON, cell 1 ON, cell 2 ON
Reminder Reset (Control Panel only)
Fan UP
Clears the maintenance reminders after performing
routine maintenance.
Fan
DOWN
Battery
compartment
(2 AAA)
PERFORM CLEANING
(approx . every 30 days)
The unit requires
cleaning . See the General Maintenance
section of this owner's manual . We recommend you:
• Clean the rear lint screen (see page 6)
• Vacuum the
• Vacuum front and rear grill openings
RESETTING THE REMINDERS
The only reminder you need to reset is the PERFORM
CLEANING reminder (after performing maintenance, press the
Reminder Reset button and the screen will momentarily display
CLEARED to let you know the reminder has been cleared) . All
the other service reminders will clear automatically once the
unit has been turned off and back on and the problem has been
corrected .
Fan and Ionization ON, cell(s) OFF
Fan and Ionization ON, cell 1 ON)
ActivePure® cell
5

Publicité

Table des Matières
loading

Table des Matières