Lcd Display - vollara FRESH AIR EVEREST Mode D'emploi

OPERATION
1 . Adjust the fan speed to your preference, keeping in mind that
higher fan speeds will give better results .
2 . Using the PURIFIER button, set the unit to RCI PUR . LOW for
increased effectiveness . NOTE: When unit displays RCI PUR .
LOW, cell 1 is on . When unit displays RCI PUR . HIGH, both
cells are on .
Fan Speed
RCI PUR. OFF: Fan and ionization are on. The ActivePure®
cell is turned off.
PLACEMENT OF UNIT

LCD DISPLAY

The LCD Screen is used to display all current settings
(see above) as well as any maintenance reminders .
Fan Speed
Reminders
(normally blank - reminders appear here when
unit needs maintenance)
4
ActivePure Cell Setting
Place the unit as high as possible to ensure the
best purification . (On top of a bookshelf, high
cabinet, etc .)
Suggested locations listed in the order of
preference:
1 . Nearest the source of the worst pollution .
2 . Near a cold-air return to thoroughly circulate
the benefits of your FreshAir Everest
throughout the area .
3 . In the area most heavily used to achieve
maximum benefit .
Purifier Setting
Fan Speed ActivePure Cell Setting
RCI PUR. LOW: Fan, ionization, and ActivePure® cell is on.
Use this setting for general usage.
Fan Speed ActivePure Cell Setting
RCI PUR. HIGH: Fan, ionization, and both ActivePure® cells
are on.
Note:
• The rear of the unit should always
have at least one inch of open area
to allow unrestricted airflow
• Point the unit towards the center
of the room for maximum
dispersion of ions
• To prevent injury, be sure the
power cord is not accessible to
small children
LCD SCREEN BACKLIGHT
As adjustments are being made, the LCD screen backlight
will brighten and the settings on the screen will change .
After 3 seconds without change, the backlight will return
to normal .
If a maintenance reminder or a service reminder
appears, the backlight will brighten and constantly
flash until the Reminder Reset button is pressed or
the service problem is corrected.