Connection Cable - AEG HD634170NB Notice D'utilisation

• This appliance is supplied with a mains
cable. It has to be supplied with a cor-
rect plug which can hold the load that
the rating plate rates. Make sure that
you install the plug in a correct socket.
• Always use a correctly installed shock-
proof socket.
• Make sure that there is an access to
the mains plug after the installation.
• Do not pull the mains cable to discon-
nect the appliance. Always pull the
mains plug.
• There is a risk of fire when the appli-
ance is in connection with an exten-
sion cable, an adapter or a multiple
connection. Make sure that the
ground connection agrees with the
standards and regulations.
• Do not let the power cable to heat up
to a temperature higher than 90° C.
To prevent contact between the cable
and the appliance below the hob use
the clamps which are on the side of the
cabinet.
8.6 Assembly
A — supplied seal
A
A) Rigid copper pipe or flexible pipe of
stainless steel
8.5 Replacement of the

connection cable

To replace the connection cable use on-
ly H05V2V2-F T90 or equivalent type.
Make sure that the cable section is appli-
cable to the voltage and the working
temperature. The yellow/green earth
wire must be approximately 2 cm longer
than the brown (or black) phase wire.
A
R 5mm
490
min.
55mm
ENGLISH
min.
500mm
min.
50mm
min.
2mm
+1 mm 560
+1 mm
19