AEG HD634170NB Notice D'utilisation page 16

16 www.aeg.com
The sensor fields be-
come hot.
comes on
comes on
and number come on There is an error in the appliance.
comes on
There is no spark when
lighting the gas.
The flame is blow out im-
mediately after ignition.
The gas ring burns un-
evenly.
If there is a fault, first try to find a solu-
tion to the problem yourself. If you can-
not find a solution to the problem your-
self, speak your dealer or the local Serv-
ice Force Centre.
Problem Possible cause and remedy
The cookware is too large or you put it too near to
the controls. Put large cookware on the rear cook-
ing zones if necessary.
• The automatic switch-off operates. Stop the ap-
pliance and start it again.
• Overheating protection for the cooking zone op-
erates. Switch off the cooking zone. Switch on the
cooking zone again.
• No cookware on the cooking zone. Put cookware
on the cooking zone.
• Not correct cookware. Use the correct cookware.
• The diameter of the bottom of the cookware is
too small for the cooking zone. Move cookware
to a smaller cooking zone.
Disconnect the appliance from the electrical supply
for some time. Disconnect the fuse from the electri-
cal system of the house. Connect again. If
on again, speak to the After Sales Service.
There is an error in the appliance, because a cook-
ware boils dry or you use not correct cookware.
Overheating protection for the cooking zone oper-
ates. The automatic switch-off operates.
Switch off the appliance. Remove the hot cookware.
After approximately 30 seconds switch on the cook-
ing zone again. The error message should disap-
pear, residual heat indicator can stay. Cool down
the cookware and check it with the section Cook-
ware for the induction cooking zone.
• There is no electrical supply. Make sure that the
unit is connected and the electrical supply is
switched on. Examine the house electrical instal-
lation fuse.
• Burner cap and crown are placed uneven. Make
sure that the burner cap and crown are in correct
positions.
Thermocouple is not heated sufficient. After light-
ing the flame, keep the knob pushed for equal or
less than 10 seconds.
Burner crown is blocked with food residues. Make
sure that the injector is not blocked and the burner
crown is clear of food particles.
comes