Display
3.6 Residual heat indicator
WARNING!
heat!
4. DAILY USE
WARNING!
Refer to the Safety chapters.
4.1 Ignition of the burner
WARNING!
Be very careful when you use
open fire in kitchen environment.
Manufacturer decline any re-
sponsibility in case misuse of the
flame
Always light the burner before
you put cookware.
To light the burner:
1.
Turn the control knob counterclock-
wise to the maximum position (
) and push it down.
2.
Keep the control knob pushed for
approximately 5 seconds; this will let
thermocouple to warm up. If not, the
gas supply will be interrupted.
3.
Adjust the flame after it is regular.
If after some tries the burner
does not light, check if the crown
and its cap are in correct posi-
tions.
Power function is active
The automatic switch off is active
Risk of burns from residual
Description
The induction cooking zones make the
heat directly in the bottom of the cook-
ware. The glass ceramic is heated by the
residual heat of the cookware.
A)
Burner cap and crown
B)
Thermocouple
C)
Ignition candle
WARNING!
Do not keep the control knob
pushed for more than 15 sec-
onds.
If the burner does not light after
15 seconds, release the control
knob, turn it into off position and
try to light the burner again after
minimum 1 minute.
In the absence of electricity you
can ignite the burner without
electrical device; in this case ap-
proach the burner with a flame,
push the relevant knob down
and turn it counter-clockwise to
maximum gas release position.
ENGLISH
9
A
B
C