Ryobi TSS102L Manuel D'utilisation page 10

MITER FENCE
The miter fence on the compound miter saw has been
provided to hold your workpiece securely against when
making all cuts. The right side is larger providing additional
support.
MITER LOCK HANDLE
See Figure 3.
The miter lock handle securely locks the saw at desired
miter angles. Tighten the handle to lock the saw in place. To
release the saw, loosen the handle and squeeze the detent
release lever.
MITER SCALE
The miter scale has index points provided at 0°, 15°, 22.5°,
30, 31.6°, and 45°.
POSITIVE STOPS ON MITER TABLE
Positive stops have been provided at 0°, 15°, 22.5°, 31.6°,
and 45° on both the left and right side of the miter table.
NOTE: To bypass the positive stops, squeeze the detent
release lever and lift the detent override. To release the
override, squeeze the detent release lever.
SELF-RETRACTING LOWER BLADE GUARD
The lower blade guard is made of shock-resistant, see-
through plastic that provides protection from each side of
the blade. It retracts over the upper blade guard as the saw
is lowered into the workpiece.
SLIDE BARS
When unlocked, the saw arm will glide forward and backward
the length of the slide bars for cutting various workpiece
widths.
SLIDE LOCK KNOB
The slide lock knob locks and unlocks the sliding feature
of this tool.
SPINDLE LOCK BUTTON
See Figure 4.
The spindle lock button locks the spindle and stops the
blade from rotating. Depress and hold the lock button while
installing, changing, or removing blade.
FEATURES
SWITCH TRIGGER
See Figure 4.
To prevent unauthorized use of the compound miter saw,
disconnect it from the power supply and lock the switch in the
off position. To lock the switch, install a padlock (not included)
through the hole in the switch trigger and make certain the
switch is inoperable. If the switch is still operable with the
padlock installed, a padlock with a larger shackle diameter
must be used. Store the padlock key in another location.
SPINDLE
LOCK BUTTON
10 − English
PADLOCK
HOLE
PADLOCK
SWITCH
TRIGGER
SWITCH
TRIGGER
Fig. 4