Operating Elements And Connections; Safety Notes; Applications - IMG STAGELINE TXS-400SET Mode D'emploi

Please unfold page 3. Then you can always see the
operating elements and connections described.

1 Operating Elements and Connections

1.1 Receiver
1 POWER LED
2 Reception LED
3 Overload LED AF PEAK [independent of volume
control AUX VOLUME (8)]
4 On/off switch POWER
5 Jack SUPPLY 12 V
plug-in power supply unit supplied
6 Antenna
7 Control SQUELCH for adjusting the muting threshold
8 Volume control AUX VOLUME for the output level
of the jack AUX (9):
Important! Do not set the control to zero if the sig-
nal is received at the XLR jack (10).
9 6.3 mm output jack AUX for connection to an un-
balanced microphone input or to a highly sensitive
line input of a mixer or an amplifier
10 XLR output BAL MIC for connection to a balanced
microphone input of a mixer or an amplifier
1.2 Microphone with integrated transmitter
11 Screw cap
12 Battery compartment for a 9 V battery
13 On/off switch
lower position: Off
mid-position: Mute, LED (14) lights up
upper position: On, LED (14) lights up
14 Power LED
if the LED does not light up with the microphone
switched on, the battery is exhausted
for the power supply via the

2 Safety Notes

The units (microphone, receiver, plug-in power supply
unit) correspond to all required directives of the EU
and are therefore marked with
WARNING The power supply unit is supplied with
hazardous mains voltage (230 V~).
Never make any modifications on the
power supply unit. Inexpert handling
may cause an electric shock hazard.
Please observe the following items in any case:
The units are suitable for indoor use only. Protect
them against dripping water and splash water, high
air humidity, and heat (admissible ambient tempera-
ture range 0 – 40 °C).
Even if the receiver is switched off, the plug-in power
supply unit has a low power consumption.
Do not operate the receiver and immediately dis-
connect the plug-in power supply unit from the mains
socket
1. if there is visible damage to the plug-in power sup-
ply unit or to the receiver,
2. if a defect might have occurred after a unit was
dropped or suffered a similar accident,
3. if malfunctions occur.
In any case the units must be repaired by authorized
personnel.
For cleaning only use a dry, soft cloth, by no means
chemicals or water.
No guarantee claims for the units and no liability for
any resulting personal damage or material damage
will be accepted if the units are used for other pur-
poses than originally intended, if they are not correctly
connected, operated, or not repaired in an expert way.
If the units are to be put out of operation de-
finitively, take them to a local recycling plant
for a disposal which is not harmful to the envi-
ronment.

3 Applications

The wireless microphone system consists of a micro-
phone with integrated, battery-operated transmitter
and antenna, a corresponding receiver as well as a
plug-in power supply unit. This system allows wireless
transmission of music and speech from the micro-
phone to the receiver. The operating range is approx.
30 m and depends on the local conditions.
The microphone system is available in two different
versions and for two different transmission channels
(or frequencies) each:
Model Frequency
TXS-400SET 433.05 MHz
TXS-402SET 433.55 MHz
TXS-440SET 433.05 MHz
TXS-442SET 433.55 MHz
In case of two models with different frequencies, it is
therefore possible to transmit signals from two micro-
phones on different channels.
.
System
Non-diversity
Non-diversity
Diversity
Diversity
7