Husqvarna TS 66 R Manuel D'utilisation Et D'entretien page 32

12 Adjusting the traverse
Adjusting the carriage on the rail [
This adjustment is necessary only if the wheels (D)
no longer bear on the rail (R). (Contact points 1 and
2 on the wheels).
• Loosen the 2 nuts (A), opposite side of the disc
using a N° 13 wrench, then tighten the screws (C)
using a N° 6 wrench (not supplied)
• Re-tighten the 2 nuts (A) and slide the carriage
over the length of the rail (R) to check adjustment.
• Fine tune the adjustment if necessary.
13 Lateral table extension
• Position the extension to the left, or the right, to
ensure maximum stability when cutting large size
materials.
14 Important advice
• Tighten all the nuts and bolts regularly.
• When storing the machine, we recommend remo-
ving the blade and storing it carefully.
• Check that there is sufficient water supply during
operation.
• Tighten the blade firmly.
• Make sure the contact faces of the flanges, blade
and axle are clean.
The manufacturer declines all responsi-
bility for loss or damage resulting from
misuse or any modification, alteration
or powering that does not conform to
the manufacturer's original specifica-
tions.
The noise level of this machine is mea-
sured according to the S 31.069 stan-
dard.
At the work station, the sound pressu-
re level may exceed 85 db (A)
In this case individual protection mea-
sures must be taken.
24
15
9].
SEE FIG.
16
For rapid delivery of spares and in order to avoid
any wasted time, it is necessary to remind your sup-
plier of the details shown on the instruction plate on
the machine with each order, as well as the refe-
rence of the part to be replaced.
17
• Main materials :
The instructions for use and spare parts found in this
document are for information only and are not binding.
As part of our product quality improvement policy, we
reserve the right to make any and all technical modifica-
tions without prior notice.
Repairs
Contact your supplier who is entirely at
S
your service to carry out repairs in the
A
shortest time at the best possible price.
V
Spare parts
00000000
Item number
See exploded view
Scrapping
In the event of deterioration and scrap-
ping of the machine, the following
items must be disposed of in accor-
dance with the requirements of the
legislation in force.
Motor : Aluminium (AL), Steel (AC),
Motor : Copper (CU), Polyamide (PA)
Machine : Steel sheet (AC), Cast iron (FT)
(0)
Quantity