Inspection Schedule - Terrier FBK Mode D'emploi

11b PROCEDURE SAFETY INSPECTION
All inspections and repairings must be written down in the maintenance diagram.
This counts not only for your own inspections but also for inspections which are carried out
by your authorised Terrier distributor. When the clamp is handed in for maintenance and
inspection you always must provide the maintenance diagram.
Defective Lifting Clamps
When a form of wear or damage is indicated, you must take the following measures.
1 Take the lifting clamp out of use. (Note the date of failure of the lifting clamp)
2 Try to recover the cause of the failure, for example (complete list is available in chapter 1.
These claims stated in no.2 do not fall under the guarantee! To guarantee the security of
you and your colleagues you are obliged to follow up this procedure.
3 Return your lifting clamp (with the maintenance history) to your authorised Terrier dis-
tributor.
4 If the lifting clamp has been revised / repaired by your distributor, you can safely use your
clamp again. Please note this date in your maintenance chart (see page 31).
11c INSPECTION SCHEDULE
Months
Years
Safety inspections by
your own inspector
Maintenance by an
official Terrier distributor
Revision by an official
Terrier distributor
16
4 8 12 16 20 24 28 32 36 40 44 48 52 56 60
1 2 3 4 5