Terrier FBK Mode D'emploi page 12

- Remove all grease, oil, dirt, corrosion and mill scale from the beam at the point where
the clamp is to be attached.
- The surface hardness of the beam must not exceed 37 HrC (345 Hb, 1,166 N/mm2).
- The clamp is only suitable for use in normal atmospheric conditions.
Safety precautions
- Ensure that the lifting shackle can never be subjected to 15º lateral load.
- A free fall or uncontrolled swaying at the crane hook resulting in objects being struck
may cause damage to the clamp. If this occurs, check whether the clamp is in good work-
ing order before using it.
- Lifting clamps are not suitable for creating permanent joints.
- The clamp should be subjected to preventive maintenance on a monthly basis in accord-
ance to the guidelines described in Chapter 6 - Maintenance.
- Do not modify the clamp (by welding, grinding, etc.), as this can adversely affect its
operation and safety, thereby nullifying any forms of guarantee and product liability.
- For the very same reason, use only original Terrier components.
- Any improper use of the clamp and/or failure to observe any directions and warnings in
these operating instructions concerning the use of this product may endanger the health
of the user and/or bystanders.
FBK
Y
TOBK
X
U
X
12
max.
15°
100%
D
90°
D
100%
0°
100%
0°
0°
60°
100%
max.
15°
max. max.
15° 15°
100%
90°
max. max.
0°
15° 15°
100%