Quick TCD Série Mode D'emploi Et D'installation page 14

CHARACTERISTICS AND INSTALLATION
GB
TCD REMOTE CONTROLS
The TCD series remote control systems have been designed to control the stern or bow thrusters manufactured
by Quick .
®
Other important advantages of the TCD series remote controls are:
• Simple and intuitive user interface.
• Universal power supply (from 8 to 30 Vdc).
• Can work in a wide range of ambient temperatures.
• Possibility of connecting several TCD controls in parallel.
• Easy to install by means of 2-wire connector (optional extensions).
• Automatic priority system.
• Automatic disablement.
• Protection against reverse polarity, short circuit output, prolonged activity of motor and interruption of thrust-
er controls wiring.
• Acoustic signals (that can be deactivated).
INSTALLATION
BEFORE USING THE CONTROL PANEL, READ THIS INSTRUCTION MANUAL CAREFULLY.
IN CASE OF DOUBTS, CONTACT QUICK® CUSTOMER SERVICE OR YOUR LOCAL DEALER.
F
In case of discordance or errors in translation between the translated version and the original text in the
Italian language, reference will be made to the Italian or English text.
F This device was designed and constructed for use on recreational crafts.
Other forms of use are not permitted without written authorization from the company Quick
The TCD series remote controls have been designed and constructed for the purposes described in this instruc-
tion manual. Quick shall not be held responsible for any direct or indirect property damage or personal injury
®
caused by inappropriate or unintended use of the equipment, incorrect installation or any errors that may be
present in this manual.
THE WARRANTY SHALL BE VOID IF THE CONTROL PANEL IS TAMPERED WITH OR ALTERED BY NON
AUTHORISED PERSONNEL
THE PACKAGE CONTAINS: TCD remote controls - frame - drilling template - user's manual - conditions of
warranty.
INSTALLATION OF CONTROL PANEL
The typical installation procedure is described herein. Needless to say, it is not possible to describe a procedure
applicable for all situations that may be encountered.
Adapt this procedure to satisfy your own personal requirements.
Locate the most suitable position to house the instrument following the recommendations given below:
• The control panel must be positioned so that it can easily be reached by the operator.
• Select a clean, smooth and fl at area.
• Access from the rear must be available for installation and maintenance purposes.
• There must be enough space behind the chosen position in order to accommodate the rear of the control
panel and the wires.
• The rear part of the control panel must be protected from water and damp.
• Pay careful attention when drilling the panel or parts of the boat.
This hole should not weaken or break/crack the boat's structure.
14
.
.
®
TCD1022 D/1042 D - REV004A