Setting Up The Connection; Fuse Replacement; Voltage Selection - HH Electronics Vector VRE-8AG2 Mode D'emploi

TWS
True Wireless Stereo is a feature that allows for the connection of two VRE cabinets to a Bluetooth
capable device. The result is a true stereo system via Bluetooth with the first VRE providing the left and the
second providing the right portion of the stereo image.
Bluetooth source

SETTING UP THE CONNECTION

BT
-BT-
Switch off and disconnect the power cord before proceeding.

FUSE REPLACEMENT

1.) Slide out the fuse holder tray.
2.) Only replace fuse with the same
type and power rating as specified
on the rear panel.
© 2021 HH Electronics Ltd
PRIMARY VRE cabinet
1. Connect the first VRE cabinet to a Bluetooth capable device as
shown on the previous page.
Using the Mode switch, select Bluetooth mode on secondary cabinet,
then hold the MODE switch for a further 5 - 10 seconds, then release.
BT will appear on the display of both cabinets (flashing on and off) and
indicates the TWS connection is in progress.
3. Once the connection has been established, the image (to the left)
will appear on the display of both Primary and Secondary cabinet.
Designed and Engineered in the UK by HH Electronics LTD.
SECONDARY VRE cabinet

VOLTAGE SELECTION

110-120V setting
110-120V~
VOLTAGE SELECT
220-240V setting
110-120V~
VOLTAGE SELECT
Using a suitable tool, slide the voltage
selector switch to the required
operating voltage.
220-240V~
220-240V~
6