Table des Matières
Publicité
VRE-12AG2
VRE-15AG2
1/2. CH1 and CH2: Mono Input channels.
3. LEVEL: Use the Level control to set the channel
volume.
4. LINE INPUT: An unbalanced input - for higher
output line level devices eg. - keyboard, processor,
drum machine.
5/5a. MIC/LINE INPUT: Use the push button (5a)
to switch the XLR Skt between:
MIC: a balanced input for low level, low
impedance devices eg. -mic (200-600 Ohms) or
electro-acoustic guitar.
LINE (via XLR Input): A balanced input for
higher output line level devices eg. -
keyboard/drum machine.
6. CH3 LEVEL: Use this control to adjust the level of
the onboard USB/SD player or an external (line
level) signal feed connected to the AUX IN.
7. AUX IN: This gives you the option to connect an
additional line level device. Control the Level with
CH3 Level control. Please use a stereo cable.
8. MIX OUT: A BALANCED signal feed that can be
used to connect to a second VRE cabinet (daisy
chained - see page 8), active wedge monitor,
house PA or recording console for example.
9. POWER LED: This will illuminate when the unit is
powered up. There is also a second power LED on the front of the cab.
10. CLIP LED: Illuminates just before the amplifier begins to clip. Adjust the level controls and signal level
from your source so this illuminates only briefly on peaks in the music.
11. MASTER VOLUME: Controls the overall level of your VRE cabinet.
12. Active BASS and TREBLE: These controls allow you to boost or cut the low/high frequency
response of the amplifier.
13. HEAT SINK: Cooling fins for the amplifier. Do not obstruct.
14. INFORMATION: Area relating to the amplifier: Serial Number, operational information, power
rating, etc.
15. VOLTAGE SELECT SWITCH: Although every effort has been made to select the correct voltage
for the region of use, please check before powering up for the first time. Damage could occur is
the voltage it incorrectly set. See page
16. MAINS SWITCH: Turns the system on and off. Ensure the Level/Volume controls are at minimum
when switching on and off.
17. MAINS INLET SOCKET AND FUSE: IEC input for connection of an appropriate mains lead. Only
replace the fuse with the type indicated for your mains voltage.
special attention to additional safety information on rear panel.
© 2021 HH Electronics Ltd
6
for more information.
Designed and Engineered in the UK by HH Electronics LTD.
1
2
CH 1
CH 2
3
4
5a
5
110-120V~
VOLTAGE SELECT
15
See page 6
for more information. Pay
6
11
CH 3
MASTER
7
8
14
220-240V~
16
17
9 9
10
12
13
4
Publicité
Table des Matières
