Functions - Castel XELLIP 500.5600 Mode D'emploi

MASTER STATION WITH TFT DISPLAY

FUNCTIONS

The master station was designed to communicate, via IP network, with other stations in the range of intercom IP
(XELLIP, CAPIP...), with a softphone, a SIP phone, or any other devices compatible with the SIP standard.
General functions of the master station
•
Configure a network connection
•
Configure a SIP account
•
Set the date and time manually or via a NTP server
•
Manage audio and video communication
↘ Set a priority level on the station
↘ Set a time-out call and communication
↘ Automatic answer with and without delay
↘ Activate the privacy mode on the automatic answer
•
Manage the display screen to personalize the home message or the delay for the screen saver...
•
Manage the keyboard to set the delay before to lock...
Audio interface functions
•
Set the loud-speaker and microphone volume
•
Set the type of communication (full duplex / half duplex)
•
Set the level of ambient noise reduction
•
Configure the RTP port number
•
Validate/Cancel audio codec
•
Set tones and ringtones
•
Configure DTMF commands for example to control the local relay
•
Configure the noise detection
•
Switch to simplex using a DTMF command:
↘ '*' switch to listen
↘ '#' switch to speak
↘ '0' go back to the normal mode
Video interface functions
•
Configure the RTP port number
•
Validate/Cancel video codec
•
Configure the bandwidth
Programmable buttons functions
Each button is programmable and allows:
•
Make a call from 1 to 10 stations simultaneous or temporized
•
Control the local relay, the station relay in communication
•
Send a DTMF code
•
Activate a call forwarding
•
Activate a call transfer
•
On master station with a handset: Switch from the handset to free hand
•
On master station without handset: Switch to the headset with or without the ringing to the station
•
Others functions like: enable the mode "do not disturb", "lock the keyboard"...
Functions of the input interface
•
Configure the input of type STATE or COUNTER
•
Configure the active state of the input (open or closed)
•
Configure a timer for acknowledging a change in state (bounce-free function)
•
Configure the counter threshold
•
Inhibit the input
Functions of the output interface
The relay output interface is programmable, and can be used to:
•
Configure the type of output relay: monostable, bistable or flashing
•
Configure the type of contact: Normally Open / Normally Closed
•
Control the On/Off output
•
Control the Force Open / Closed output
•
Configure time settings of the output
Datasheet n° 604-0001L www.castel.fr
FR
EN
Page 13 / 16