Castel XELLIP 500.5600 Mode D'emploi page 10

MASTER STATION WITH TFT DISPLAY
CONNECTION
FR
EN
Reset Button
E T R C
Connecting the power supply
A 15-30V power supply is required.
Note: The station can be powered by the POE network
Connecting the IP network
The connection is made by Ethernet 10/100 Mbits RJ45.
Connecting the relay outputs
The connection is made using a 3-point terminal that provides the "Contact (C) / Rest (R) / Office (W)" interface.
If you use one of these relay outputs to control a 12, 24 or 48V AC or DC latch, connect an unpolarised 58V diode in
parallel with the dry contact between C and W or C and R depending on the use (diode included).
Connecting the input
An input TOR allows the connection of a dry contact (do not apply power) to be activated, the input must be pulled to
ground.
Contact can be deported to 1km.
Datasheet n° 604-0001L www.castel.fr Page 10 / 16