Functions - Castel XELLIP Serie Fiche Technique

XELLIP MONITOR

FUNCTIONS

The monitor was designed to communicate, via IP network, with other stations in the range of intercom IP (XELLIP,
CAPIP...), with a softphone, a SIP phone, or any other devices compatible with the SIP standard.
General functions of the master station
•
Configure a network connection
•
Configure a SIP account
•
Set the date and time manually or via a NTP server
•
Manage audio and video communication
↘ Set a priority level on the station
↘ Set a time-out call and communication
↘ Automatic answer with and without delay
↘ Activate the privacy mode on the automatic answer
•
Manage the display screen to personalize the home message or the delay for the screen saver...
•
Manage the keyboard to set the delay before to lock...
Audio interface functions
•
Set the loud-speaker and microphone volume
•
Set the type of communication (full duplex / half duplex)
•
Set the level of ambient noise reduction
•
Configure the RTP port number
•
Validate/Cancel audio codec
•
Set tones and ringtones
•
Configure DTMF commands for example to control the local relay
•
Configure the noise detection
•
Switch to simplex using a DTMF command:
↘ '*' switch to listen
↘ '#' switch to speak
↘ '0' go back to the normal mode
Video interface functions
•
Configure the RTP port number
•
Validate/Cancel video codec
•
Configure the bandwidth
Function of the gate control button
The button is programmable and allows:
•
Control the station relay in communication
•
Send a DTMF code
Functions of inputs interfaces
•
Configure the input of type STATE or COUNTER
•
Configure the active state of the input (open or closed)
•
Configure a timer for acknowledging a change in state (bounce-free function)
•
Configure the counter threshold
•
Inhibit the input
Functions of open collector outputs interfaces
Open collector outputs interfaces are programmable, and can be used to:
•
Configure the type of output: monostable, bistable or flashing
•
Configure the type of contact: Normally Open / Normally Closed
•
Control the On/Off output
•
Control the Force Open / Closed output
•
Configure time settings of the output
Functions of the logical input (or flags)
Logical input allows 2 kinds of functionality:
•
Create a logic from which it will be possible to condition actions in relations
•
Create a counter which will be updated as events and depending on the value of this counter start one or
more actions if required.
Datasheet n° 604-0032G www.castel.fr
FR
EN
Page 13 / 16