Oceanic OCEAISH1750W1 Guide D'utilisation page 41

1. Blower description:
Power switch:
1.1 Turns to
time, the working mode of the fan and the rack can be controlled by the remote
controller or Fan switch, but the remote the first time you use the remote control, you
need to configure the code according to the method in next page, you can use this
product after completing the code matching.
1.2 turns to
same time, The working mode of the fan and the rack cannot be controlled by the
remote control or Fan switch.
2. Fan heater switch:
2.1 When the device is in standby mode, the fan heater switch's green light will
be always on, short press the fan switch device fan to start heating alone (Red
light flashing at 1Hz), the frame is not heated at this time, after 30 min heating
the device enters standby mode. If you short press the Fan heater switch again in
the heating state, the fan stops heating and returns to the standby state.
2.2 In the state of remote control, press the blower fan switch to start heating
fans alone (Red light flashing at 1Hz), the radiator rack stop heating at the same
time, the device enters standby after 30 minute. If you press the Fan heater
switch again in the heating state, the fan stops heating and returns to the
standby state.
, Power on, the fan and rack enter standby at the same
, Power off, the fan and the rack are powered off at the