Oceanic OCEAISH1750W1 Guide D'utilisation page 32

•
WARNING: In order to avoid a hazard for very young children, this appliance
should be installed so that the lowest heated rail is at least 600 mm above the
floor.
• Do not use this heater with a programmer, timer, separate remote control
system or any other device that turns on the heater automatically because there
is a risk of fire if the device is covered or placed incorrectly. Use only a remote
control device connected by the pilot cable.
• The device must be powered by a Residual Current Device (RCD) with a rated
operating differential current of not more than 30 mA.
• The device must be connected to a circuit independent electric protected by a
bipolar circuit breaker according to the standard electrical installation NF C 15-
100.
• CAUTION: To avoid hazard due to inadvertent resetting of the thermal cutout,
this appliance must not be powered via an external switch, such as a timer, or
connected to a circuit that is regularly switched on and off by the electricity
supplier.
• The heater must be installed so that switches and other control devices can not
be touched by a person in the bath or shower.
• A means of disconnection from the power supply having a contact opening
distance of all poles must be included in the fixed wiring in accordance with the
installation requirements.
• For your safety, the device is equipped with a thermal circuit breaker. In the
event of overheating, the power supply will be cut off.
• With respect to the details of how to install the appliance onto the wall, refer to
the "INSTALLATION" section.
• Regarding the detailed information on the connection of the electric cable, refer
to the section "ELECTRICAL CONNECTION".
Ref: OCEAISH1750W1\OCEASHS1750B1\OCEASHS2000W1\OCEASHS2000B1
Radio frequency bands used by the Transceiver 2412MHz to 2472MHz
Maximum radio frequency power: <100mW
The undersigned, OCEANIC, declares that the radio equipment of the electric towel