Stiebel Eltron HSBC 300 cool Utilisation Et Installation page 44

INSTALLATIoN
Installation
f Insert the temperature sensor into the sensor well provided. f
Electrical connection HSBC 3-HKM
MKP (X2.4)
BK BU GNYE
L
N
M
1~
MA11
BT13
f Wire up the heating circuit pump and 3-way mixer (see chap- f
ter "Installation / Electrical connection / Control voltage").
44 | HSBC 300 cool | HSBC 300 L cool
XD03.3
MISCHER (X2.14)
BN BK BU
L N
M M
1~ 1~
MA19
10.2.3 If necessary, install an HSBC 3-HE auxiliary heating
element as an accessory
1
1 Blank flange
2 Insulation segment
f Remove the insulation segment in front of the flange plate. f
f Remove the blank flange. f
5
1
1 Earthing contact PE
f Move the auxiliary heating element into the correct instal- f
lation position. Use the position of the earthing contact as a
guide.
f Install the auxiliary heating element. Observe the tight- f
ening torque (see chapter "Installation / Specification /
Accessories").
2
3
1
www.stiebel-eltron.com