Stiebel Eltron HSBC 300 cool Utilisation Et Installation page 41

INSTALLATIoN
Preparation
Joining appliance sections
Rejoin the appliance sections in reverse order.
The positioning aids and the dotted line marking provide assis-
tance when positioning and inserting the upper appliance section
into the guide groove on the lower section:
5
1 Handle
2 Guide pin
3 Dotted line (perforation in the panel)
4 Guide groove
5 Positioning aid
1 Dotted line (perforation in the panel)
f Place the upper appliance section onto the lower appliance f
section along the dotted line.
www.stiebel-eltron.com
1
f Slide the upper appliance section to the back until it is flush f
with the lower appliance section. If the appliance sections
are joined correctly, the final position is determined by the
2
guide groove and guide pin.
f Secure the tabs on the appliance front. f
3
f Fit the side profile strips. f
f Fit insulation segment 3 and the 4 hydraulic hoses. f
f Connect the push-fit connectors of the 4 hydraulic connec- f
4
tions. Ensure that the spring clips click into place.
f Insert the "heating sensor" at the buffer cylinder. f
f Lay the sensor lead in the guide groove provided for this f
purpose.
f Fit insulation segment 2. f
f Fit insulation segment 1. f
f Fit the front casing. f
1
HSBC 300 cool | HSBC 300 L cool | 41