AEG SCE72716TM Notice D'utilisation page 8

8 www.aeg.com
4.6 Switching on the wine
cooler compartment
1. Press Mode until the corresponding
icon appears.
The wine cooler compartment Off
indicator flashes.
2. Press OK to confirm.
The wine cooler compartment Off
indicator goes off.
To select a different set temperature
refer to "Temperature regulation".
4.7 Temperature regulation
Set the temperature of the wine cooler
compartment and of the Freezer
compartment by pressing the
temperature regulators.
The temperature in the wine cooler
compartment can be adjusted between
+6°C and +16°C.
Default temperature settings:
• +10°C for the wine cooler
compartment
• -18°C for the freezer
compartment
The set temperature will be reached
within 24 hours.
After a power failure the set temperature
remains stored.
4.8 Frostmatic function
The Frostmatic function accelerates the
freezing of fresh food and, at the same
time, protects foodstuffs already stored
from undesirable warming.
1. To activate this function press the
Mode button until the corresponding
icon appears.
The Frostmatic indicator flashes.
2. Press the OK button to confirm.
The Frostmatic indicator is shown.
This function stops automatically after 52
hours.
To switch off the function before its
automatic end repeat the procedure
until the Frostmatic indicator turns off.
The function switches off by
selecting a different set
temperature.
All manuals and user guides at all-guides.com
4.9 High temperature alarm
An increase in the temperature in the
freezer compartment (for example due to
an earlier power failure) is indicated by
flashing the alarm icon and freezer
temperature indicators, and sounding of
buzzer.
Press any button.
The buzzer switches off.
The freezer temperature indicator shows
the highest temperature reached for a
few seconds, then displays the set
temperature again.
The alarm indicator
continues to flash until the
normal conditions are
restored.
4.10 Door open alarm
If the door is left open for approximately
5 minutes, the acoustic alarm starts and
alarm indicator flashes.
The alarm will stop after closing the
door. During the alarm, the acoustic
signal can be muted by pressing any
button.
4.11 ChildLock function
Activate the ChildLock function to lock
the buttons from unintentional
operation.
1. Press Mode until the corresponding
icon appears.
The ChildLock indicator flashes.
2. Press OK to confirm.
The ChildLock indicator is shown.
To deactivate the ChildLock function,
repeat the procedure until the ChildLock
indicator goes off.
4.12 DrinksChill function
The DrinksChill function is to be used to
set an acoustic alarm at the preferred
time, useful for example when a recipe
requires to cool down food products for
a certain period of time.
It is also useful when a reminder is
needed in order not to forget the bottles
placed in the freezer for fast cooling.