AEG SCE72716TM Notice D'utilisation page 14

14 www.aeg.com
Problem
A square symbol is shown in-
stead of numbers on the
Temperature Display.
The lamp does not work.
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the Frostmatic, or
after changing the tempera-
ture.
Water flows on the rear
plate of the wine cooler .
Temperature cannot be set.
All manuals and user guides at all-guides.com
Possible cause
The temperature in the ap-
pliance is too high.
Temperature sensor prob-
lem.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor-
rectly.
The Frostmatic function is
switched on.
This is normal, no error has
occurred.
During the automatic de-
frosting process, frost
melts on the rear plate.
The Frostmatic or Cool-
matic function is switched
on.
Solution
Contact a qualified electrician
or contact the nearest Author-
ised Service Centre.
Contact the nearest Author-
ised Service Centre (the cool-
ing system will continue to
keep food products cold, but
temperature adjustment will
not be possible).
Close and open the door.
Contact the nearest Author-
ised Service Centre.
Refer to "Operation" chapter.
Wait some hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
Refer to "Frostmatic function".
The compressor starts after a
period of time.
This is correct.
Switch off Frostmatic or Cool-
matic manually, or wait until
the function resets automati-
cally to set the temperature.
Refer to "Frostmatic or Cool-
matic function".