CIAT CS2B Manuel D'installation page 14

Á¿ ½»Íʽ ÁÊ½Ë ÌÇ ½ÊÅÁÆ¹Ä ÌÊÁÈ
9. Push any excess wire into wall and against mounting
base. Seal hole in wall to prevent air leaks. Leaks can
affect operation.
10. Snap case back together. Attach thermostat to back
plate by inserting tab on bottom edge and hinging up
until top snap secures. See Fig. 4.
11. Close thermostat assembly making sure pins on back
of circuit board align with sockets in connector. Turn
ON power to unit.
12. Turn ON power to unit.
14
7. Adjust length and routing of each wire to reach
proper terminal and connector block on mounting
base with 6.5mm of extra wire. Strip only 6.5 mm of
insulation from each wire to prevent adjacent wires
from shorting together when connected. See Fig. 2.
 -ATCH AND CONNECT EQUIPMENT WIRES TO PROPER
terminals of the connector blocks. The unit manual
SPECIlES TO WHICH TERMINAL BLOCKS THE .5) HAS TO BE
connected.
&OR CONNECTION TO 7 # ' 9 REFER TO lG A FOR
CONNECTION TO 2C 2H ' 9 REFER TO lG B
Á¿ Ľ»ÌÊÁ»¹Ä ¼Á¹¿Ê¹Å
Á¿ Ì̹»À