Plumbing - Miele PWM 514 Mode D'emploi

Unscrew the screws at the bottom of the back panel and remove

the panel.
Loosen the hexagon screws to remove the transport safety devices.

Retain the transport safety devices. They need to be refitted should
the machine ever need to be moved again.

Plumbing

Water pressure (flow pressure) of a minimum 1 bar (100 kPa) / max-
imum 10 bar (1000 kPa) is required to guarantee problem free pro-
gramme operation.
The machine must be connected to the water supply using the inlet
hoses provided.
Hoses must be replaced with hoses tested for a burst pressure of at
least 70 bar (7000 kPa) and for water temperatures of a minimum of
90 °C.
This also applies for associated connection fittings. Miele original re-
placement parts fulfil these requirements.
Tip: The hot water supply must not exceed a maximum temperature
of 60 °C.
en - Installation
183