Applications - WELDY energy HT1600 Instructions D'utilisation

Applications

This hot-air tool is intended for all of the hot-air applications listed here, subject to compliance with safety regulations and the utilization of original Weldy accessories:
• Welding of all thermoplastic synthetic materials • Shrinkage & forming of thermoplastic synthetic materials
• Welding of foils & plastic sheeting
DE
Warning
EN
FR
DANGER! Danger when opening up the tool, as live components and
ES
connections are exposed. Therefore, before opening it, unplug the tool
PT
to ensure disconnection from the mains. Before putting into operation,
IT
check power supply cord and connector as well as extension cable for
NL
electrical and mechanical damage.
DA
Incorrect use of the Hot Air Tool (eg. overheating of the material) can
SV
present a fire and explosion hazard, especially near combus t ible
NO
materials and explosive gases.
FI
Do not touch the heating element housing and air nozzle when
EL
they are hot as they can cause burns. Let the tool cool down. Do
TR
not point the hot air flow in the direction of people or animals.
PL
HU
Attention
CS
The voltage rating stated on the tool must correspond to the mains
SK
voltage.
RO
SL
For personal protection on building sites we strongly recommend
BG
the tool be connected to a RCCB (Residual Current Circuit Breaker).
ET
The tool must be operated under supervision. Heat can ignite flam-
LT
mable materials which are not in view. The machine may only be used
LV
by qualified specialists or under their supervision. Children are not
RU
authorized to use this machine.
JA
Protect tool from damp and wet.
ZH
AR
Repairs should only be carried out by authorized service points.
TH
Restricted to use with original Weldy accessories and spare parts.
KO
4
Original Operating Manual
• Activation/detaching of solvent-free adhesives & hot melt adhesives • Soldering of copper pipes, solder connectors & metal foils
• Drying of watery-moist surfaces
Warranty
• For this tool, the guarantee or warranty rights granted by the relevant distri-
butor/seller shall apply. In case of guarantee or warranty claims any manu-
facturing or workmanship defects will either be repaired or replaced by the
distributor at its discretion. Warranty or guarantee rights have to be verified by
an invoice or a delivery document. Heating elements shall be excluded from
warranty or guarantee.
• Additional guarantee or warranty claims shall be excluded, subject to mandato-
ry provisions of law.
• Warranty or guarantee shall not apply to defects caused by normal wear and
tear, overload or improper handling.
• Warranty or guarantee claims will be rejected for tools that have been altered
or changed by the purchaser.
Conformity
Leister Technologies AG, Galileo-Strasse 10, 6056 Kaegiswil/Switzerland,
confirms that these products, in the versions as brought into circulation th-
rough us, fulfil the requirements of the following EC directives.
Directives: 2006/42, 2014/30, 2014/35, 2011/65
Harmonized EN 12100, EN 55014-1, EN 55014-2, EN 61000-3-2
Standards: EN 61000-3-3, EN 62233, EN 60335-1, EN 60335-2-45,
EN 50581
Kaegiswil, 19.01.2018
Bruno von Wyl, CTO Christoph Baumgartner, GM