Table des Matières
Publicité
FOLDOUT TABLE STANDS
The foldout table stand legs are located on the backside. Pull the stands out from
the bottom center edge of the timer wall clock, below the battery compartment.
Once the foldout table stands are extended, place the timer wall clock in an
appropriate location.
WALL MOUNTING
1.
Using a straightedge, horizontally space at 40 mm three screw positions
on a wall.
2.
Install three mounting screws (not included) into a wall within transmission
range— leaving approximately 5mm extended from the wall.
3.
Place the timer wall clock onto the screws, using the hanging holes on the
backside. Gently pull the timer wall clock down to lock the screws into
place.
Note: Always ensure that the timer wall clock locks onto the screws before
releasing.
CARE AND MAINTENANCE:
Avoid placing the unit in areas prone to vibration and shock as these may cause damage.
•
Avoid areas where the unit can be exposed to sudden changes in temperature, i.e. direct
•
sunlight, extreme cold and wet/moist conditions as these will lead to rapid changes which
reduces the accuracy of readings.
29
Publicité
Table des Matières
