Techno Line WS 8100 Mode D'emploi page 28

TO ENTER AND SET THE TIMER
1. Press the TIMER / MEMO / SNZ key. Default setting "0:00".
2. Set the timer with the SET / MIN keys for the minutes, and the + / SEC keys for the seconds.
If the + / SEC or the SET / MIN key is held, the seconds or the minutes will increase by 2.
TO START / STOP THE TIMER COUNDOWN
1. After the timer has been set, press the ALARM / START / STOP key to start the countdown.
2. Press the ALARM / START / STOP key to stop the countdown anytime.
3. When the countdown reach "0:00", an alarm sound will be heard. It will keep ringing for 30
seconds. The timer will also starts counting up. Press any key to stop the count up.
Note:
If the count up is stopped while the alarm is ringing, the LCD will show the timer set time.
•
If the count up is stopped after the alarm finished ringing (after 30s), the timer will show the
•
stop time.
TO RESET THE TIMER
Press and hold the SET / MIN and the + / SEC keys at the same time to reset the timer to "0:00"
MULTIPLE TIMER SETTINGS
A maximum of 8 timers countdown can be stored and recalled.
To set multiple timer:
1. Press the TIMER / MEMO / SNZ key to enter the timer setting mode.
2. Set the timer with the SET / MIN (minutes) and + / SEC (seconds) keys.
3. Press the ALARM / START / STOP key to record the timer.
4. Press again the ALARM / START / STOP key to stop the countdown and set a new time.
5. Use the SET / MIN and + / SEC keys respectively to set a new time.
6. Keep repeating the same steps from 2 - 4 for additional setting of the timer.
27