Language Setting - Techno Line WS 8100 Mode D'emploi

LANGUAGE SETTING

The weekday can be displayed in LCD2 with the pre-set languages: German (d), US English (US),
French (F), and Spanish (E). (Default language: German):
1. Set the desired language for the weekday display in LCD1 by use of the + / SEC key.
2. Press and release the SET / MIN key to exit the setting mode and switch back to the normal
display mode.
EXIT THE MANUAL SETTING MODES
To return to the normal display mode from anywhere in manual setting mode, simply press
•
the TIMER / MEMO / SNZ key anytime.
If no keys are pressed for about 15 seconds in setting mode, the timer wall clock will
•
automatically switch back to normal display mode.
TIME ALARM SETTING
To enter into the time alarm setting mode:
1. Hold the ALARM / START / STOP key for 2 seconds. The hour digits start flashing.
2. Press the SET /MIN key to set the hour.
3. Press the ALARM / START / STOP key to set the minutes. The minute digits start flashing.
4. Press and release the + / SEC key to set the minutes. If the + / SEC key is held, the unit will
increase by 5.
5. Press again the ALARM / START / STOP key to exit the alarm setting mode or wait for 15
seconds automatic timeout.
Note:
The alarm duration is 90 seconds. To stop the alarm, press any key, except the TIMER / MEMO /
SNZ key.
The time alarm can only be set if the LCD is in normal mode (not in timer mode).
25