Table des Matières
Publicité
SETTING UP:
1.
Insert 1 x AA, IEC LR6, 1.5V batteries into the timer wall clock. Make sure that the polarity of
the battery is correct (see markings), and ensure that it doesn't spring free from the contacts.
2.
Once the battery is in place, all segments of the LCD will light up briefly and a brief beep
sound will be hear. Then the indoor temperature, the time as 0:00, the date as 1-1, and
weekday will be displayed. Do not press any keys for 10 minutes or until the DCF time code
has been received.
3.
The DCF time code reception will automatically start. This takes typically between 3 - 5
minutes in good conditions.
4.
If after 10 minutes the DCF time has not been received, use the SET / MIN key to enter into
the set mode and change either the time or date in order to activate the DCF reception. The
clock will then automatically attempt to receive the DCF time. When this is successful, the
received time will override the manually set time. The date is also updated with the received
time (Please refers to notes on "DCF Radio controlled time" and "Manual time setting").
Note:
In the event of changing the battery of the unit, ensure that it does not spring free from the
contacts. Always wait at least 3 minutes after removing the battery before reinserting, otherwise
start up and transmission problems may occur.
BATTERY CHANGE:
For best performance, battery should be replaced at least once a year to maintain the best running
accuracy. Ensure that the battery used is new and the correct size.
Please help in the preservation of the environment and return used batteries to
an authorized depot.
19
Publicité
Table des Matières
