Table des Matières
Publicité
MANUAL SETTINGS
Note:
If the timer wall clock has already successfully received the DCF time signal and displays
the correct time and date, then the Manual settings can be skipped.
After completion of the above described procedures in "Setting up", the manual setting modes can
be entered by pressing the SET / MIN key. The following settings can now be programmed:
12/24 time format setting
•
Manual time setting
•
Year setting
•
Month setting
•
Day setting
•
ºC or ºF temperature setting
•
Language display setting
•
12/24 HOURS TIME FORMAT SETTING
1.
The "12" or "24" will start flashing in LCD1 (Default setting 24h). Select the desired time
display mode by use of the + / SEC key.
2.
Press and release the SET / MIN key to enter the "Manual time setting".
MANUAL TIME SETTING
In case the timer wall clock is not able to detect the DCF-signal (disturbances, transmitting
distance, etc.), the time can be manually set. The clock will then work as a normal Quartz clock.
1.
The hour digits will start flashing on LCD1.
2.
Set the desired hours by pressing and releasing the + / SEC key followed by pressing the
SET / MIN key.
3.
Now the minute digits will start flashing. Set the desired minutes by pressing and releasing
the + / SEC key . If the + / SEC key is held, the units will increase by 5.
4.
Press and release the SET / MIN key to move to the "Year Setting".
23
Publicité
Table des Matières
