Bosch GCC30-4 Consignes De Sécurité/D'utilisation page 15

The following locations are suitable for attaching a GCC30-4 (see figure K):
– Surfaces where attaching the GCC30-4 does not prevent or complicate the
operation of the power tool,
– Surfaces that will not be exposed in the event that the power tool falls over,
– Surfaces with the minimum possible curvature.
Removing the GCC30-4
Do not use any sharp or pointed tools, which may cause damage to GCC30-4 or
the surface of the power tool it is attached to.
If you have to use chemicals to thin the adhesive, make sure the chemicals (e.g.
thinners) do not damage the plastic surface of a power tool or GCC30-4.
Attaching the GCC30-4 to a power cord
removing GCA30-9 retaining clip.
You can attach the GCC30-4 module to a power cord using the GCA30–9 retain-
ing clip.
- Remove the liner to expose adhesive tape on the back of GCA30-9 (Fig. L).
- Attach GCC30-4 to the adhesive back of the retaining clip GCA30-9 (Fig. M).
L
To reduce the risk of electric shock always disconnect
power cord from the power outlet before attaching or
M
15