Important - Clarke ALTO CTV Manuel D'utilisation

Figure 6
Page -20-
MACHINE OPERATION
Operating Machine
If using machine for liquid pickup, follow this procedure:
1. Leave filter cartridge and cloth filter in place
NOTE: This machine has a float shut-off.
When the water raises the float, the air
stops moving through the machine.
2. Turn machine on and begin vacuuming. The ON/OFF
switch is on top of the vacuum head assembly. Put
the switch in the "I" position to start the motor. Put the
switch in the "O" position to stop the motor.
3. When cleanup is complete, empty the liquid by
opening the drain valve on the drain hose. See figure
5.
4. For best performance, clean and rinse cloth and
permanent filters.
If using for dry pickup or to remove shampoo from
carpet, follow this procedure:
1. Use the filter bag. This will keep debris from entering
the vacuum motor.
2. Turn machine on and begin vacuuming. If pickup
efficiency decreases, stop the machine.
3. Remove the foam, liquid, dirt and carpet fibers from the
tank and from the filter bag.
NOTE: Have an extra clean filter bag avail
able for continuous operation. Use
clean filter bag while other filter bag is
being laundered and dried.
4. For best performance, clean the mesh screen around
the float often.
There are no user serviceable parts. All repairs
must be done by authorized personnel only.
Changing The Bag Type Filter
1. Pull the bag-type filter sleeve off the inlet fitting. See
Figure 6.
2. Dispose of the used bag-type filter in accordance with
the local waste disposal regulations.
3. Place a new bag-type filter into the tank as described
in the instructions printed on the filter.

IMPORTANT!

Push the bag-type filter sleeve completely onto
the inlet fitting.
Clarke
®
CTV 230V Operator's Manual