Attempting To Start; Removing The Power Pack; Use As A 12 V Voltage Supply; Compressor - EUFAB 16643 Mode D'emploi

6.3.2 Attempting to start

Start the motor. Do not operate the starter for longer than 6 seconds. The battery of the power pack is not designed for longer
starting attempts. Pause for at least 5 minutes between two starting attempts. If the motor does not start after a number of
attempts, abort the process and investigate the cause of the defect.

6.3.3 Removing the power pack

First disconnect the black (-) pole calliper, coil the cable and attach the pole calliper to the designated holder. Then disconnect
the red (+) pole calliper, coil the cable and attach the pole calliper to the designated holder. Always maintain this sequence.
Recharge the power pack.

6.4 Use as a 12 V voltage supply

The Power Pack can be used as a 12 V direct current source for many devices that can be operated with 12 V direct current and a
12 V motor vehicle charging cable. Plug the motor vehicle charging cable of the device you wish to operate into one of the 12 V
outlet (Position 12 in the overview). The device you wish to operate should not require a current greater than 10 A.

6.5 Compressor

In order to be able to work with the compressor, first remove the air hose from the storage compartment (Position 11 in the
overview).

6.5.1 Filling a tyre using the car valve (Schrader valve)

Open the lock on the valve
connection
Figure 7
To fill, switch the compressor on using the switch (Position 10 in the overview).
The manometer (Position 9 in the overview) is used to give a rough approximation of the air pressure. When the desired air
pressure is reached, switch the compressor off. Remove the valve connection in reverse order (Figures 10 – 7).
When filling, always pay attention to the correct air pressure (consult the operating instructions of your
vehicle for information). The compressor is able to supply of pressure of up to a maximum of 18 bar. If the
pressure is too high, there is a risk of explosion and injury.
Never allow the compressor to operate for longer than 10 minutes without a pause, otherwise there is
a risk of overheating. Switch the compressor off after 10 minutes of use and allow it to cool down for at
least 10 minutes before starting it up again. Never leave the compressor to operate unattended.
After filling a tyre, check the tyre pressure again using a separate air pressure tester (e.g. at a filling station, vehicle workshop).
12
All manuals and user guides at all-guides.com
Place the valve connection on
the valve
Figure 8
Lock the valve connection
Figure 9
You can now fill the tyres using
the compressor
Figure 10