Variateur D'essorage; Verrouillage Clavier; Programmation Fin Du Cycle/Départ Différé - Hoover HI1X8 Manuel D'instructions

40002960Eng.qxd 12/04/2005 15:11 Page 25

Variateur d'Essorage

On selecting the wash programme the display will inform you of the maximum
spin speed permitted for that programme. By repeatedly pressing the
Variateur d'Essorage button the speed will decrease by increments of 100 rpm.
The spin may be cancelled if desired by holding down the Variateur d'Essorage
button. On selecting the required spin speed the display will then inform you
of the chosen programme, its temperature and the newly selected spin speed.

Verrouillage Clavier

This is a useful feature to prevent children playing with the option buttons
and tampering with the programme you have set.
After you have set the programme and option buttons you require, press the
Départ/Pause button. Press the Verrouillage Clavier button and this "locks" the
control panel.
You may cancel this function by pressing the Verrouillage Clavier button
briefly until you see the light next to the button flash. While this light is
flashing, press the Repassage Facile button – the display will inform you that
the options are no longer locked and further changes can now be made.
Programmation Fin Du Cycle/Départ Différé
The Programmation Fin Du Cycle/Départ Différé options can be used if you
want the washing to be ready at a later time (but within 24 hours).
1. Départ Différé button
Press the Départ Différé/Programmation Fin Du Cycle button once and press
the hours and minutes buttons (Heures/Minutes) to the left and right until the
required time is set. The display returns to the programme option if the
button is pressed within 5 seconds. Once you have set the required Départ
Différé/Programmation Fin Du Cycle, press the Départ/Pause button.
To cancel Départ Différé, hold down the button for 5 seconds.
2. Programmation Fin Du Cycle button
Press the Départ Différé/Programmation Fin Du Cycle button once and press
the hours and minutes buttons (Heures/Minutes) to the left and right until the
required time is set. When entering the option, the display will show the
minimum time which you can set the programme to end by. This time may only
be extended as you require.
NOTE: When using the Départ Différé/Programmation Fin Du Cycle functions,
only use detergents via the dispenser drawer. Adding detergents etc. to the
drum and then leaving them to stand for a long period of time may damage
your laundry.
25