Battery And Charger; Energy Saving Modes; Standby Mode - BH iLynx Manuel

EN
USER MANUAL
5.2.11 USB.
The display panel has a USB port below the screen, to charge devices.
• Do not apply excessive force on the USB port or pull the USB cable.
• Check that the USB plug is facing in the right direction and is not
completely misaligned or at an angle with the USB port, and make sure
ATTENTION that it is fully inserted.
• Do not connect the USB port or plug if they are wet or damp.
• Use a standard-compliant USB 2.0 OTG cable.
• Do not insert foreign objects into the USB port.
• Using the USB port to charge different devices may affect the bicycle's
range, reducing the battery's capacity.
NOTE
• When an external device is connected to the USB cable, power is
supplied automatically.
• If the battery's remaining capacity is low, no power will be supplied.
46
iLynx iLynx

5. BATTERY AND CHARGER

5.1 Technology
The battery that your BH bike is equipped with contains lithium-ion cells and is the most advanced technology
available in terms of energy density (energy stored per kilogram of weight and per cm
Lithium-ion batteries have the following characteristics:
A) Their performance decreases in extremely hot or cold environments.
B) One additional characteristic of BH lithium-ion batteries is that they have no "memory effect",
and are not affected by incomplete discharging.
C) They lose their charges naturally and gradually with use. The battery can be fully discharged (100%)
approximately 500 times, with maximum battery deterioration of 20%. In the case of partial discharges, only the
discharged part is counted. For example, if we charge the battery every time its charge level falls by 25%, we will
be able to charge it to 100% of its initial capacity 2,000 times.
In short, the guaranteed durability of the battery with maximum degradation of 20% is at least 20,000 km.

5.2 Energy Saving Modes

The battery has been designed to ensure a long service life. This is possible thanks to the energy saving modes:
5.2.1 Transport Mode (only during the first use)
In order to minimise internal consumption while transporting the bicycle from the factory to the store, the battery
is in Transport mode.
The user can finally exit this Transport mode by charging the battery to 100% before its first use.
ATTENTION
5.2.2 Stand By Mode
In order to minimise internal consumption, the battery automatically switches to Stand By mode. This happens
automatically when the system detects no charging, no discharging and no communication with the battery for
a period of 10 minutes. So, for example, this mode will automatically turn off the display panel after 10 minutes
without use, if the user has left it on after parking.
The user can exit this Stand By mode by simply turning on the bicycle's display panel.
USER MANUAL
of volume).
3
If the battery does not charge fully, the Transport mode will not deactivate,
repeatedly entering this mode quickly for its protection.Remember to fully
charge the battery to finally deactivate the Transport mode.
EN
47