Technical Specifications; Cleaning, Maintenance And Storage - BH iLynx Manuel

EN
USER MANUAL
8.3 Liability
A) BH assumes no liability for damage to (parts of) the bicycle caused by the incorrect fitting of the moving parts
of the bicycle, unsuitable use and/or maintenance of the bicycle (including the late replacement of wearing parts).
B) If BH accepts a warranty claim, this in no way implies acceptance of liability for any damages incurred. In the
event of a dispute over (subsequent) damages suffered, BH disclaims all liability in that regard,
as it is not legally bound to compensate them.
Any unauthorised handling of the components of the electrical system may
NOTE
be dangerous and will be grounds for invalidating the warranty.

9. CLEANING, MAINTENANCE AND STORAGE

Do not use high-pressure washers or jet stream cleaners, as they may cause
ATTENTION water ingress, damaging the system, the motor, the display panel or the battery.
If water enters one of these units, ask an authorised dealer to check your bicycle.
9.1 Battery Care
Keep the battery clean. Use a damp and properly wrung out cloth to clean dirt from the battery case. Do not pour
water directly onto the battery, e.g. with a hose.
Do not clean the contacts by polishing them with a file or using a wire, etc.
ATTENTION
Otherwise, it may cause failures.
9.2 Motor Maintenance
Because the motor is a precision machine, do not disassemble it or exert excessive force on it (e.g. do NOT hit
this product with a hammer).
9.3 Storage
Keep the bicycle in a place that is:
• Flat and stable
• Well ventilated and dry
• Protected from the elements and direct sunlight
9.4 Prolonged Storage
If you are going to store the bicycle for a prolonged period (1 month or more), remove the battery and store
it as follows.
• Make sure that the remaining battery capacity is above 50% and then store it indoors, in a cool
(10 to 20°C) and dry place.
• Check the remaining battery capacity once a month, as the battery is slowly discharged while
in storage. If the capacity is below 50%, charge it until it is above 50%.
• When using it again after a prolonged period of storage, be sure to charge the battery before use.
52
iLynx iLynx

10. TECHNICAL SPECIFICATIONS

10.1 Motor
• Direct Current BH Motor.
• 200 W power. / Maximum assistance speed 25 km/h.
• System voltage: 36 V.
10.2 Battery
• Lithium-ion battery.
• Battery voltage: 36 V.
• Capacity: 540 Wh.
10.3 XPro Battery
• Lithium-ion battery.
• Battery voltage: 36 V.
• Capacity: 180 Wh.
It is an Upgrade Kit although in some models it comes standard.
EN
USER MANUAL
53