Initial Start-Up; Finishing Work; Function Check; Documents - Truma iNet X Panel Instructions De Montage

Initial start-up

5 Initial start-up
Switch on the power supply to all connected appli-
ances, such as a heater or air conditioning system�
When the power is switched on, the setup wizard is dis-
played on the control panel after a few seconds�
The setup wizard recognises the connected appliances
and guides the user through the start-up procedure�
This includes choosing the language and other settings,
depending on the configuration�
If a new or replaced appliance, such as a heater or
air conditioning system, is connected to the bus sys-
tem, you have to search for the appliance manually in
Settings�
22 EN
Truma iNet X Panel / Truma iNet X Pro Panel
6

Finishing work

6.1

Function check

Check all functions of the control panel and the con-
nected appliances in accordance with the operating
instructions�
6.2

Documents

Hand over the operating instructions to the user or
vehicle owner�
47000-00082 · 01 · 11/2021