Help In Case Of Malfunction - elem ELDEEP3740 Mode D'emploi Et D'entretien

HELP IN CASE OF MALFUNCTION

Malfunction
Motor does not run.
Pump running, but does not
feed.
Delivery rate too low
In the event of a malfunction that you cannot rectify, please contact our Customer Service
department.: sav@eco-repa.com
Disconnect the mains plug before any fault rectification work!
Faults in the electrical system must be rectified by a qualified electrician.
Possible cause
Impeller blocked
Thermal protection switch has
switched off.
No mains power.
Blockage on the suction side.
Pressure line closed off.
Pressure hose kinked.
Hose diameter too small.
Blockage on the suction side.
Feed head to high
CAUTION!
Remove dirt from the suction
area.
Wait until the thermal protection
switch on the immersion pump
switches on again. Take note of
the maximum temperature of
the conveying medium.
Have the immersion pump
inspected
Check fuses, have the power
supply checked by a qualified
electrician.
Remove dirt from the suction
area.
Open the pressure lone.
Extend the pressure hose.
Use a hose with a bigger
diameter.
Remove dirt from the suction
area.
Observe max. feed head, see
technical data!
Solution