elem ELDEEP3740 Mode D'emploi Et D'entretien page 18

Electrical safety
Danger from contact with
Immediately disconnect the
plug from the mains if the
extension cable has
been damaged or cut. We
recommend connection via
an earth leakage circuit
breaker (ELCB) with a rated
leakage current < 30 mA.
The pump may not be operated while people
are in the pool or pond.
The mains voltage at your location must
comply with the information regarding mains
voltage in the Technical Data. Do not use any
other supply voltage.
The appliance must only be operated on
electrical equipment in accordance with DIN/
VDE 0100, parts 737, 738 and 702. For fuse
protection, a circuit breaker of 10 A and an
earth leakage circuit breaker with a rated lea-
kage current of 10/30 mA must be installed.
Only use extension leads approved for out-
door use with a minimum cross-section
of1.5 mm2. Always fully unwind cable drums.
Damaged or fragile extension cables may not
be used.
➯ Check the condition of you extension ca-
ble prior for every use.
If the connection cable must be extended,
only a cable type H07RN-F and a moulded
sleeve must be used. This work must only be
carried out by an electrician.
AUTION!
live parts!
INSTALLATION
Mounting the pressure line
The pump has a check valve on the
pump outlet. This prevents the pressure
line being emptied each time the pump
stops.
1. Mount the pressure line (03/1) on the
pressure line connection (03/2).
2. Attach the connection cable (03/3) to the
pressure line with cable ties (03/4).
3. Prior to immersion of the pump in the well
and shafts, attach the enclosed cable to the
cable lugs (03/5).
STARTUP
Safety
Exclude, by suitable means,
that, in the event of a fault in
the immersion pump,
consequential damage is
caused by flooding.
Operate the immersion pump hanging on a
cable.
Operate the appliance only if the immersion
pump is fully immersed.
Always observe sufficient distance to the
base of the shaft (min. 1 m).
Never allow the immersion pump to run
against a closed off pressure line.
When using in shafts, make sure the size is
adequate.
Always cover the shaft with a secure foot
plate.
1. Unscrew (04/a) both fastening screws
(04/1) of the pump base (04/2).
2. Remove (04/b) pump base (04/2) from
the pump (04/3).
CAUTION!