Bosch 1613AEVS Mode D'emploi page 14

BM 2610943371 07-06.qxp
CENTERING THE SUB-BASE AND
TEMPLET GUIDES
Your router features the Bosch "Precision
Centering Design". Its sub-base is precisely
centered at the factory. This positions the bit at
the center of the sub-base and optional templet
guides. Precision centering allows you to closely
follow jigs such as straight guides, templets,
and dovetail fixtures without worrying about bit
walk-off from the intended cut line for any
reason, including the orientation of the router's
handles.
In the event the sub-base screws are loosened
or removed, such when preparing the router for
use in a router table, here's how to re-center
the sub-base when reattaching it:
To quickly re-center the sub-base, attach the
sub-base using the set of flathead screws
(included) and the countersunk screw holes in
the sub-base. (Flathead screws have the
tapered heads.) The flathead screws and
countersunk holes will pull the sub-base into a
position that is very close to centered.
FIG. 15
CENTERING CONE
(optional accessory)
TEMPLET GUIDE
(optional accessory)
A
B
D
GUIDING THE ROUTER
The router can be guided through the work in
any of several ways. The method you use
depends, of course, on the demands of the
particular job and on convenience.
For routing operations such as grooving or
dadoing, it is often necessary to guide the tool
in a line parallel to a straight edge. One
method of obtaining a straight cut is to
securely clamp a board or other straightedge
to the work surface, and guide the edge of the
router sub-base along this path (Fig. 16).
7/24/06 9:03 AM
All manuals and user guides at all-guides.com
OR — To most precisely re-center the sub-
base, attach the sub-base using the optional
Bosch centering cone, an optional Bosch
templet guide, and the set of pan-head screws
(included). (Pan-head screws have rounded
tops.) Follow steps 1-8.
1. Position the sub-base so that its pan-head
2. Insert the pan-head screws, not the flathead
3. Insert templet guide (optional accessory) the
4. Slide centering cone (optional accessory)
5. Tighten collet nut with fingers to put slight
6. Lightly press centering cone into templet
7. Tighten the pan-head screws.
8. Remove centering cone. The precision
D
A
C
B
A
B
C
D
FIG. 16
-14-
Page 14
screw holes are over the matching set of
threaded holes in the base.
screws, through the sub-base and tighten
them until they are snug, but still allow the
sub-base to move.
installed template guide adapter as
described elsewhere in this manual.
through templet guide and into collet. Use
narrow end of cone when inserting into 1/4"
collet, wider end of cone when inserting into
1/2" collet.
grip on centering cone.
guide to center guide and sub-base.
centering of the templet guide and sub-base
is complete.
A = M4 COUNTERSUNK SCREW
SUB-BASE
HOLES
B = M4 PAN-HEAD SCREW HOLES
C = TEMPLET GUIDE ADAPTER
SCREW HOLES
D = HOLES FOR ATTACHING
ROUTER TO ROUTER TABLE
MOUNTING PLATE
BOARD
GUIDE
FEED
DIRECTION
SECURELY
CLAMP BOARD
GUIDE